Initial requirements for the installation of a recycling system are the detailed characteristics of the application.

- Defining the amount of spoilage 
   or contamination in the applicable 
   material.
- Defining the final usage of the 
   finished product.

Based on these specifications we would be in a position to engineer and manufacture a complete modular system for the application.

Typical system for processing baled material:

1. Pre-size reduction
(Single-Shaft-Shredder / 
Two-Shaft-Shredder/Bale Breaker)
for breakdown and/or size reducing the baled film waste. The slow rotating pre-size reducer is equipped with a large capacity in-feed hopper which will accept numerous bales for the pre-size reduction process.

2. Discharge conveyor belt
for removal of the size-reduced material from the pre-size reducer.

3. High efficient air aspirator (HS series)
is positioned above the discharge belt for separation of coarse foreign material from the material flow and to protect the down stream components.

4. Flake silo (FS series)
for pre-storage and consistent feeding of the down stream components.

               

5. Pre-soaking screw
for preparation of the material to the next 
stage intensive cleaner.

6. Intensive cleaner (IW series)
for intensive surface removal of the water solfable foreign contamination from the material.

7. Material transport system
for removal of the material from the intensive cleaner and transport to the down stream granulator.

8. Granulator

for size-reduction of the material to the final product size.

                

9. Material transport system

for removal of the material from the granulator.
 

10. Separation tank (TB series)

              

11. Diverter screw

for transport and diversion of the material to the down stream dryer.

12. Mechanical dryer (TM series)
for mechanical surface drying of the product.

               

13. Thermal dryer (TT series)

for final drying of the film flakes to a residual

moisture content of less then 1% in weight.